Jet oil mist lubrication system

The system control and monitoring functions with the same A/B two-way system, automatic switch and manually switch the system to work consistently.

Cyclical, alternating pulsed high-pressure air delivery, to maximize the role of the compressed air to the limit, you can save under the lubricant to the bearing surface jet.

Unique spray technology, can be overcome "gas barrier" phenomenon, enabling effective spray mist to wet bearing surface, at the same time a large number of heat away to extend the service life of bearings.

Condensed unique mouth design, a greater degree of the condensed oil mist to increase the rate.

Oil mist generation and transmission by the PLC and the host PC is equipped with control and communication cables through the system state will be sent to the operating room to monitor the system after the adjustment can be achieved without man-made technological requirements.

Each oil mist device for 50-100 meter radius of the lubrication points, lubrication.

Fully functional remote computer monitoring system, we can make sure the system failure occurred was found in a timely manner.

System working principle

0.3~0.5MPa pressure compressed air (available purification wind instrument) by the air filter,air heater, solenoid valve connected to electricity,then decompression by pressure regulating valve,so that air pressure to reach the working pressure of Health fog.

After decompression of the compressed air after the oil mist into the generator, the generator with high-speed flow of air through the eddy current effect arising from the atomization process, the oil inhalation aerosol generator for atomizing chamber. The role of the air stream was split into small particles of mist 1~3μm (ultrafine oil mist).

Atomized mist to dry after about 3~5KPa pressure through the mains and the branch pipe to the lubrication point.

At this point the concentration of oil mist in the standard conditions, per cubic meter concentrations of oil mist in the 3-12g/m³, mist in the pipeline for the transmission rate of 5-7m/s.

Each site are equipped with lubrication condensed mouth, dry oil mist, as condensed, the continuous uniform dispersion to the bearing surface.

And injection system in the injection pressure 0.3~0.5MPa under the periodicity, pulse, will be condensed down mouth Department save the larger size of the spray mist to wet the surface bearings.

At this point in the mist particle size of about 40-100 microns to form a big wet adhesion mist.